I have tried everything it is in dual mode. Shared view disabled. Set to the correct channel. If I run RCA TV2 works fine. I have even run a coax straight from TV2 out to TV2 with the result. Box has been replaced. Any help would be useful
TV2 coax only will output TV1 signal
- Thread starter towboy123
- Start date
- Latest activity Latest activity:
- Replies 8
- Views 2K
What channel do you have the TV2 set on? Power the TV off, then back on to confirm.
Also, what receiver model are we working with?
Also, what receiver model are we working with?
Initial guess is either the cable is connected to a TV1 only output, or the TV2 is set to the wrong channel
Also this was my 2nd day of training and my trainer has 9 years with Dish
Checked both for sure, Dish Tech support was stumped as well figured I'd reach out to the community on this. It seems the TV2 Coax output is stuck on TV1.
Go to menu-6-1-5 and turn off TV1's modulator. Can you also confirm that the mode says "Dual Mode" in the system info screen? Or, if the TV2 can go to channel 73, change the modulator setup to cable
The receiver output is set on the Local Channels screen and can be off-air or cable, some tv's will scan what is set. If receiver is set to off-air, tv should be set to antenna. If the tv is set to cable and tv1 is on a low channel number while tv2 is on a higher channel number the tv will pick up tv1 but not tv2.
