Secure dual RG6 to stucco

[Shawn95GT]

I know a lot of installers frequent the forums here so I figured this is as good of place as any to ask.

I'm looking for suggestions on how to secure a run of dual RG6 + a single RG6 cable to a stucco wall. The cable is from what was an existing Dish Network install. The cables were re-used when I had Voom installed. It's been over a year since the Voom dish was in use and the recent wind storms have managed to pull the cable from my wall. Now I have a RG6 pair hanging from my 2nd story eve .

Plastic anchors have worked well securing my cable box etc. It there something readily availalble that I can screw into one of these anchors to keep the cable affixed to my exterior wall?

Thanks!

 

[Van]

Check with any of the advertisers to see if they have any plastic single and dual coax screw clips under a fastener heading, these work great and you can find them in two diferent screw lengths.

 

[Shawn95GT]

Thanks! I think I found exactly what I was looking for.

These are similar to what the installer had used, only they had used the nail in type. These screw it ones should work out great.


Shawn