Hi
I am a dish newb
I believe my model is dish622
I recently moved my sat and I have a dual tv Dvr. Everything is fine on tv1 until the Dvr returns from stand by mode. There is "no signal" after sleep mode. I haven't hooked up TV2 yet but as far as I know it's all the same as before. I can get tv back by going to setup, point dish, and check switch then it re downloads everything and its fine until it enters sleep mode again. Also I can't seem to switch the Dvr to single mode, on the front panel nothing happens.
I've rebooted and reseated my card. Does anyone know something I can do to fix this. Any info is much appreciated. Thanks
I am a dish newb
I believe my model is dish622
I recently moved my sat and I have a dual tv Dvr. Everything is fine on tv1 until the Dvr returns from stand by mode. There is "no signal" after sleep mode. I haven't hooked up TV2 yet but as far as I know it's all the same as before. I can get tv back by going to setup, point dish, and check switch then it re downloads everything and its fine until it enters sleep mode again. Also I can't seem to switch the Dvr to single mode, on the front panel nothing happens.
I've rebooted and reseated my card. Does anyone know something I can do to fix this. Any info is much appreciated. Thanks