could someone tell me something

[arod_6949]

i am getting ready to upgrade to a 3 room system and i am getting a new dish and everything it will be the dish with the 3 lnb. i was wanting to know if it is hard to just install this dish yourself? i installed the dish i have now and have all my wires already done so would it be hard to install this dish myself?

 

[medicalwaste]

not at all. i had my wires set up from before, so when i picked up my new 3 lnb set, all i had to do was mount the dish on the pole and just rotate it until i picked up all 3 sat signals at 90 level.

i used set up dish menu in the receiver to get the coordinates and adjusted dish mount before i went up on the roof. so when i got up there, i already had my elevation and tilt set. all i had to do was just rotate the dish after putting it on the pole. it took less than 10 sec. to find the signals..

good luck

 

[Cwaters]

Not hard at all. If you installed the system you have now, it's the same process but easier since you already have your angles down.

CW

 

[jimisham]

If it's going on a pole, the pole must be plumb. No tilt or lean in any direction.