My 622 started acting squirrely two days ago by losing the sat signal after being on a channel for 2-3 minutes but I was able to change to an adjacent channel on the guide and it would operate properly for a couple of minutes and and then start the same cycle over again. I was not even able to get to my EHD in the 2-3 minute span of proper operation without the "Lost Satellite Signal" screen appearing.
I unplugged the receiver for a "hard boot" and then ran a check switch which indicated all OK for the three sats on both inputs. The Sys Info screen also looks good but when the program guide info downloads, it will only complete aboout 95% of the progress bar and then locks up. If stop the download, the channels will operate properly (do not lose sat signal) but I only have abour two hours of EPG info.
Anyone else having problems with L617 or am I just lucky?
Both my 222's seem to be operating OK. Dish is coming next week to install a 1000.4 and switch me to the EA for local HDs but this seems like a receiver issue.
Any advice will be appreciated.
I unplugged the receiver for a "hard boot" and then ran a check switch which indicated all OK for the three sats on both inputs. The Sys Info screen also looks good but when the program guide info downloads, it will only complete aboout 95% of the progress bar and then locks up. If stop the download, the channels will operate properly (do not lose sat signal) but I only have abour two hours of EPG info.
Anyone else having problems with L617 or am I just lucky?
Both my 222's seem to be operating OK. Dish is coming next week to install a 1000.4 and switch me to the EA for local HDs but this seems like a receiver issue.
Any advice will be appreciated.