Hopper 1 Software H183, Hopper 2 Software H283, Hopper 3 Software H383, Hopper Duo Software H483 and Hopper Plus Software P13106 released & available

[Bobby]

The setting (under Notifications) shows caller ID turned off. Fixed! One of my updates must have flipped that. I am on H383.

Interesting, a few of us have tested that and we noticed CID worked with that setting both on and off. Perhaps it needs tto be initially turned on for it to take effect.

 

[charlesrshell]

I wonder how many things in the Notifications stay enabled even when toggled off. So far, it's the Caller ID and the Remote Control Mode Reminder.

For my Hopper 3 the remote control reminder works properly. For my Hopper 3 Plus setup it does not. I have it set to off but still get the reminder.

 

[Jim5506]

We have noticed since H383 that while the skip forward works within a specified program on PTAT, if you try to skip the commercials ,etc at the end of a program to watch the next program it says Live TV and fails to go to the next recorded program.

I've tried backing up and Fast Forwarding through the end of program barrier but that also fails. Sunday night after watching Tracker we had to exit PTAT and go to the recorded programs on PTAT and select Equalizer before we could watch Equalizer. Skip forward is working fine within each program but will not allow you to proceed to the next program on PTAT while PTAT is still active (recording).

 

[bookworm370]

I have seen the same problem. The end of the previous show (whatever was paused) is prepended to the front of the new one. And the new one does not have a play function (you have to press the play button on the program icon)

 

[bookworm370]

The setting (under Notifications) shows caller ID turned off. Fixed! One of my updates must have flipped that. I am on H383.

You tested it once you flipped it??

 

[Almighty1]

For my Hopper 3 the remote control reminder works properly. For my Hopper 3 Plus setup it does not. I have it set to off but still get the reminder.

Maybe the issue is with the Hopper Plus software because Pepper also has the Hopper Plus and I do as well and specifically mentioned the Hopper Plus software update caused it in this comment.

 

[charlesrshell]

Maybe the issue is with the Hopper Plus software because Pepper also has the Hopper Plus and I do as well and specifically mentioned the Hopper Plus software update caused it in this comment.

I agree with you. The H+ is causing several issues. But I am hanging in there with it. My wife really likes using one remote smoothly accessing the aps.

 

[RTCDude]

RTCDude - Couldn't test it now as my internal HDD is full but what do you have for Settings -> Timer Defaults for the Start and End settings?

1 minute early and 3 minutes late.