Configure UHF Pro 8.0 remote for my 522??

[skerz]

I've got a used UHF Pro 6.0 that i use with my 522, but it just doesn't work too well. I have a new UHF Pro 8.0 that is just sitting there that I was using with my 811 (until I got a universal). Can someone provide me guidance about how to configure the UHF Pro 8.0 to control my 522 TV1 (rf, not ir).
Thanks a million.

 

[Pepper]

1. Configure the address on the remote to the same thing as your IR remote.

2. Look for "TV1 UHF Pro" on the 522 menus and enable it. (I think it's either under setup or preferences)

3. Just for good measure, push the System Info button on the front of the receiver, arrow up with the old IR remote to highlight TV1, then press record on the new remote.

 

[skerz]

Thanks!