Hey All,
Been researching on your forum and on the net all day for help, and decided to finally post my problems and hopefully you can help.
We are working on getting satellite to work at our tailgate and have run into some interesting problems.
Setup:
We have a coaxial going from the first lnb output going to a splitter that splits it to the two inputs on the back of the receiver for sat 1 and 2. We setup the satellite and point the dish as the correct azimuth (we have tailgaters right next to us using Dish as well and have identical angle to the sky and our dishes are only 3-4 ft apart). We first run a check switch with nothing connected to clear any previous connections (as this box is used at our home). We then connect everything and run the check switch again. It always fails with xx's and red boxes across the board. Now no matter how many times we run the check switch, we are unable to get it to pass. When we then reconnect the lnb to our dish at home, it works without any problems (rule out bad lnb). We have successfully gotten the exact setup to pull a signal at our house with a terrrible line of site to clear sky. Once we get to tailgate, sure enough we fail to get passed the check switch. We have tried several coaxials, as well as various ways of connecting the dish to the box (removing the splitter etc)
My question to you, is there something we are fundamentally missing? Would being slightly not level or barely of the correct azimuth cause the check switch to fail completely?
Any help would be greatly appreciated. Sorry if I didn't provide enough information, let me know anything else you might need to know.
Our tailgating location is 2 miles from the house the box is registered at.
Been researching on your forum and on the net all day for help, and decided to finally post my problems and hopefully you can help.
We are working on getting satellite to work at our tailgate and have run into some interesting problems.
Setup:
- 1000.2 lnb
- Dish is a circular Dish Network dish (do realize we won't get hd) on a tripod mount purchased from a Dish installer.
- Receiver is a 722
We have a coaxial going from the first lnb output going to a splitter that splits it to the two inputs on the back of the receiver for sat 1 and 2. We setup the satellite and point the dish as the correct azimuth (we have tailgaters right next to us using Dish as well and have identical angle to the sky and our dishes are only 3-4 ft apart). We first run a check switch with nothing connected to clear any previous connections (as this box is used at our home). We then connect everything and run the check switch again. It always fails with xx's and red boxes across the board. Now no matter how many times we run the check switch, we are unable to get it to pass. When we then reconnect the lnb to our dish at home, it works without any problems (rule out bad lnb). We have successfully gotten the exact setup to pull a signal at our house with a terrrible line of site to clear sky. Once we get to tailgate, sure enough we fail to get passed the check switch. We have tried several coaxials, as well as various ways of connecting the dish to the box (removing the splitter etc)
My question to you, is there something we are fundamentally missing? Would being slightly not level or barely of the correct azimuth cause the check switch to fail completely?
Any help would be greatly appreciated. Sorry if I didn't provide enough information, let me know anything else you might need to know.
Our tailgating location is 2 miles from the house the box is registered at.