Resuming on Joey

[Hall]

On more than a few times and with different recordings, when I select a show to watch, I get the prompt showing where and how much it's been watched. It works fine if I choose the Hopper location and resumes properly. If I stop it on the Joey and want to resume again, I can't. It only shows that original Hopper stopping point and it should be showing two options.

Anyone else see this happen?

Sent from my ADR6400L using Tapatalk 2

 

[thechaz05]

Can't say as though I have.

Posted Using The New SatelliteGuys Reader App!

 

[navychop]

Try hitting skip back.

Sent from my iPhone using SatelliteGuys

 

[gpflepsen]

Try hitting skip back.

Sent from my iPhone using SatelliteGuys

How does this help? Do you utilize this technique on the Joey or Hopper initiated session?

 

[navychop]

I honestly don't remember if I was on a Hopper or a Joey. But after hitting Pause I could not get it to resume. I tried skip back and it worked.

I'm just guessing it might work in other circumstances. Can't hurt to try.

Sent from my iPhone using SatelliteGuys

 

[gpflepsen]

Hall's talking about resuming a session after you've completely left the program, and trying to resume from the DVR menu. I think you're talking about something different.

 

[navychop]

Yes, I just reread and must've breezed thru that post way too fast.

Sent from my iPhone using SatelliteGuys

 

[Hall]

1) Watch recording on Hopper and stop before the end
2) Resume watching (after choosing the stop point from the Hopper) on Joey and stop before the end
3) Resume watching on the Joey again

There should be TWO choices to resume from: One from the Hopper and one from the Joey. I have seen it in the past and in fact, suspect it changed with S238.

Sent from my ADR6400L using Tapatalk 2