Orbitron 10ft Teardown
- Thread starter Captain Midnight
- Start date
- Latest activity Latest activity:
- Replies 7
- Views 2K
Maybe I should've searched first... Found some great info in a couple of threads. Glad this site has such a big archive!
Id bet the reflector will move without taking it apart, and it wont be that heavy. I'd go put some PB Blaster on all the bolts a couple days before I get the dish, or I'd plan to bring big breaker bars and break some bolts off. The mount will be heavier, and you can take it apart some after you get the dish off the mount. Take the feed off and the feed arms too before you do anything else. label everything. Masking tape and a sharpie are your friends.Measue the focal length too before you take it all down. Take pictures. Plan on it taking much longer than you think. LOL
Take a LOT of close up pictures, every part that gets pulled apart, you will not regret taking them.
I moved a 10' dish once in once piece like 25 years ago about 20 miles fun stuff "when I wore a younger man's clothes" Billy Joel
Good luck
I moved a 10' dish once in once piece like 25 years ago about 20 miles fun stuff "when I wore a younger man's clothes" Billy Joel
Good luck
We dropped one in about 30 minutes a few years ago with just basic hand tools and a electric screw driver. It's still sitting in my backyard. Someday I will put it up!
There are many examples of dish recovery on the forum. A couple examples of the last two I recovered.
www.satelliteguys.us
www.satelliteguys.us
KTI Rescue
I can't help it. Must be a disease. ;) While wandering around a couple days ago I came across a 10' quad panel KTI that was headed for the scrap pile. I don't need a dish and this one needs some extra love but you just don't throw away a C-Band dish, do you?
www.satelliteguys.us
Zenith rescue (Pinnacle)
I went a picked up a 10' perforated dish today. I thought it was a Winegard Pinnacle until I got close enough to see the name on it. Zenith and it was obviously made by Winegard for them. It's an exact copy of a Pinnacle. Fits a 4" OD post.
www.satelliteguys.us
The orbitron is not a hard dish to take apart start by removing the actuator arm, and then remove the quad legs and RG6 wire, next the center cap holds the whole dish together remove that, and slide out the screens, and remove the ribs and the dish is torn down.
Removing the screens usually results in a nightmare for reassembly. I concur with the above suggestions to transport in one piece. DO NOT break it apart unless it is ABSOLUTELY necessary. I have hauled many assembled10 foot reflectors on a trailer or inside a cube truck.
