Nfusion Phoenix and multi-switch issue

[kooguy]

Hi all,

I have 3 dishes, one point at 97W, one point at 95W and one point at 101W, all joined via multi-switch and connected to three receivers - ViewSat ultra, Captive Works (CW-700S), VisionSAT IV-200. All receivers are able to get signals properly, no issues at all.

Here is my current ViewSAT settings.

95W Ku
======
LNB: ON
LNB : Standard
LNB Freq: 10750
22Khz: off
TP Freq: 11780
DiSEqC 1.0: Port 4

97W Ku
======
LNB: ON
LNB : Standard
LNB Freq: 10750
22Khz: On
DiSEqC 1.0: Port 3

95W Ku
======
LNB: ON
LNB : Standard
LNB Freq: 10750
22Khz: off
DiSEqC 1.0: Port 2

Problem: I just bought Nfusion Phoenix as a spare. So I pull the CW700S out and connect the cable to Nfusion Phoenix.

Software release for Nfusion Phoenix is :
R3X 1.30
S/W R3XCAMCUBN20080_U51

However, I can only get 97W satellite to work properly with these settings..
97W Ku
======
LNB : Standard
LO. Freq. 10750
22KHz: ON
DiSEqC mode: Auto
Motor : OFF

No matter how I play with the settings on 22KHz and DiSEqC, I couldn't get the reception to work at all for following satellites.

95W Ku
======

LNB : Standard
LO. Freq. 10750
22KHz: ON
DiSEqC mode: Auto
Motor : OFF

101W Ku
=======
LNB : Standard
LO. Freq. 10750
22KHz: ON
DiSEqC mode: Auto (Disable, Mini_A, Mini_B, DiSEqC1, DiSEqC2, DiSEqC3, DiSEqC4)
Motor : OFF
============================================================

The Nfusion Phoenix has a network connection, but I dare not update software online.

Any idea what I should do?

 

[putney]

I don't have a Phoenix, but I do have an Nfusion HD. 22khz switches work fine, but SW21 are funky. I can get them to work, but the LNB type needs to be messed with (as I see you have realized)

I don't have any real answers. Did the switch burn up? Is it still working with the other boxes? What kind of switch?

I find the DiSEqC switch and motor options to be a bit confusing on my HD. I get it to work for my uses though, which essentially turbo ITC signals and OTA.

 

[kooguy]

The switches are Zinwell (4x4, 2x1) and they are working properly with other receivers other than this Nfusion unit.

I must have missed something obvious...Just can't be that difficult to set it up.

 

[kooguy]

Nerver mind...I figured out the issue. Just a little tricky to set this box up.