MOTECK SG-2100 Trouble

[madmadworld]

hi
my first post. been lerking for months. thanks for all the help i have found here.

i have a MOTECK SG-2100 i have tried it on 3 different receivers.
and it will not remember the sats. i get a few in (say 4) it will be ok and then as i add more it forgets the oldest ones.
i have tried the reset botton.

thanks for your time

 

[mastermesh]

Are you using Usals or 1.2? Also, you used the reset button on the motor??? I'm curious what angle the motor was at when you did that...

 

[voomvoom]

I'm curious what angle the motor was at when you did that...

master I thought he meant the Factory Reset for the receivers? I would like to know, which 3 receivers he tried?

Al

 

[madmadworld]

motor

Are you using Usals or 1.2? Also, you used the reset button on the motor??? I'm curious what angle the motor was at when you did that...

i have tried both Usals & 1.2 .

motor @ 0

recivers used
FORTEC STAR FSIR-5400
FORTEC STAR LIFETIME ULTRA
Pansat 2800

 

[voomvoom]

I see you also have a Stab HH100 motor, do you have these problems with this motor? I don't have an SG2100 so I'm at a loss. I find it strange that it would log up to 4 sats, especially on 3 different receivers, and then replace those when you try to log new sats into the receivers. Very strange?

Al

 

[madmadworld]

I see you also have a Stab HH100 motor, do you have these problems with this motor? I don't have an SG2100 so I'm at a loss. I find it strange that it would log up to 4 sats, especially on 3 different receivers, and then replace those when you try to log new sats into the receivers. Very strange?

Al

no the stab works fine.

i start at 116 ms6 add 103 101 97 93
then go to say 97
then ask it to go to 93 and it goes to 116