Dish Elev
I can't get my dish elev to go down to 26. According to the picture on the box it came in, it shows the small bolt all the way to the end of the gauge, well the square mounting rod on the back of the dish won't allow my dish to go down that far. At first the motor Mast(what the dish mounts onto) was to long, so with a HackSaw, I cut off 1 an 1/2 inch, but its not enough. Now I see why there aren't too many FTA Retailers down here in South Florida. I was wondering if maybe I could put washers between the top two mounts where the dish is attached to the Bracket ? That might lower my angle just enough, or maybe two washers on each? Any Feed-back will be appreciated!!