Hook up problems

[Bud Kerr]

I disconnected and took my Dish 625 receiver on a trip to Arizona last month. When I got home I reconnected it as it was before (I took pictures). Now I can't get any picture on TV2. I have gone thru the book concerning the right channel etc. Here is a drawing of the setup the Dish tech. did upon original install.

Do you see a problem?

 

[Bud Kerr]

Fior some reason the drawing (JPG) did not show.

 

[Bud Kerr]

I'll try it here.
Bud

 

[Bud Kerr]

No drawing.

Could someone tell me how to get a picture of this drawing on here?
Bud

 

[garys]

It could be you switched it to single user instead of dual user mode (bring up banner and see what setting is set). Or tv2 could have been disabled, check under menu; system setup; shared view and see if it is enabled.

 

[Bud Kerr]

garys - What do you mean "bring up banner?"

 

[Bud Kerr]

garys- neither the "Enable View" nor "Disable view" have a check mark and I couldn't get over to check either.

 

[UnSat]

if diplexed make sure the uhf side is going to tv2 ijnput/output. if hardwired do same.check connectors make sure diode is flush,stinger not bent.check modulator setting. Auto program Tv 2 to get disired channel.Some tv loose there memory if you unplugg or throw the breaker, power outage etc.