DPH42 LNB inputs - need all four populated?

[lacanadio]

I'm about to install a DPH42 to my 1000.2 setup. Can I just run the 110, 119, 129 cables to the DPH42 and leave the other LNB input disconnected? The downstream will be a wally connected to receiver port 1 via the power inserter and a hopper 3 connected to receiver port 2 via a hybrid solo hub.

I'm hoping to get this right the first time...

Thanks in advance,
Bob

 

[TheKrell]

I have never seen a DPH42, but I'm pretty sure you can leave one or even two inputs open.

 

[dweber]

I have a DPH42 switch for my 2 Hopper3 receivers. Port 1 is 119, Port 2 is 110, Port 3 is 129, and Port 4 has a terminator. 1 has the power inserter connected to the client on the Hybrid duo hub, 2 is connected to the other client on the Hybrid duo hub. The 2 To Host on the Hybrid duo hub go to each of my Hopper3 receivers and the To Client goes to my Joey3.


Sent from my iPhone using SatelliteGuys

 

[HipKat]

I'm about to install a DPH42 to my 1000.2 setup. Can I just run the 110, 119, 129 cables to the DPH42 and leave the other LNB input disconnected? The downstream will be a wally connected to receiver port 1 via the power inserter and a hopper 3 connected to receiver port 2 via a hybrid solo hub.

I'm hoping to get this right the first time...

Thanks in advance,
Bob

The 4th port on the LNB is an input. Just run 3 out to the DPH 42 Switch