I got a Dish Network Model DPP44 Power Inserter at a garage sale the other day for $.50. The power brick attached to it shows an output of 28.0V or 20.5V at 1.65A. I put a meter on it on the leg "To Switch" and it shows about 21.0V no load and 20.5V with a LNB loaded to it. It shows zero V on the leg "To receiver satellite in".
I wanted to use it as a power inserter to a Dual C feedhorn...it looks like it should be safe to put in line with a satellite receiver since it showed zero volts on the receiver leg. I am however concerned about the 20.5V power to an 18 volt LNB. Will I damage or shorten the LNB life with this extra 2.5-3.0 volts? Did Dish Network raise the voltage to compensate for longer coax runs...I would presume their LNB's only need 18V?
Also I know I'm missing the compatable Dish Network switch with this but how does the power brick 28.0V come into play here? Is it activated by a 22khz tone? Does the missing switch incorporate a voltage drop so that the LNB is only getting 18V from the power brick's 20.5V or 28V output?
I wanted to use it as a power inserter to a Dual C feedhorn...it looks like it should be safe to put in line with a satellite receiver since it showed zero volts on the receiver leg. I am however concerned about the 20.5V power to an 18 volt LNB. Will I damage or shorten the LNB life with this extra 2.5-3.0 volts? Did Dish Network raise the voltage to compensate for longer coax runs...I would presume their LNB's only need 18V?
Also I know I'm missing the compatable Dish Network switch with this but how does the power brick 28.0V come into play here? Is it activated by a 22khz tone? Does the missing switch incorporate a voltage drop so that the LNB is only getting 18V from the power brick's 20.5V or 28V output?