Your other choice is to remove the Cable from the Uniden receiver when you are not using it, this removes it from causing your problems. I use to do this before I inserted the attenuator. I attached a quick disconnect to do this on-the-fly.
Diseqc robs signal
- Thread starter boomer_106
- Start date
- Latest activity Latest activity:
- Replies 23
- Views 4K
- Status
Your other choice is to remove the Cable from the Uniden receiver when you are not using it, this removes it from causing your problems. I use to do this before I inserted the attenuator. I attached a quick disconnect to do this on-the-fly.
Are you powering off all connected receivers when you swap cables on the switches? (either by unplugging them or by the REAR switch)? These switches are VERY sensitive to voltage spikes, and a port can be burned out easily...
Hey Tron, thanks for the reply. Yes I power off the receivers before swapping cables. I even tried different ports. It all seems ok if I don't hook up the C cable
- Status
Similar threads
