D* Install on steel building

Status
Please reply by conversation.
Can you answer this question though? Why when I tried the single LNB could I only get signal on trans 22? Shouldn't of all the transponders been there?

Good question, I have no answer for you, unless there is an lnb issue.
 
What about the overhang? Could that cause me to not be able to get 101?

What is the angle from the dish to the overhang? The signals come in at about a 32 degree angle. That's 32 degrees up from the horizon. Can you post a picture?
 
What is the angle from the dish to the overhang? The signals come in at about a 32 degree angle. That's 32 degrees up from the horizon. Can you post a picture?

It is so rainy and foggy here today, but I will try to post a pic.
 
I was right on with my tilt and elevation, I was just to far west. I was shocked as to how far east I actually needed to be. Thanks for all the help from everyone who replied in the post. I would have given and chalked it up as bad location if I wouldn't have gotten all the good advice from the board. thanks again....
 
Status
Please reply by conversation.

Be careful with your h20 swapouts

HR20-700 Remote

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)