how can i hook up the two reciver so i can watch both reciver on all four tvs. i have splitters wired up right now but if i try to watch tv on the tv's that have the dish boxes wired to them the picture is fuzzy. its all wired up like a basic setup but i added a splitter to the wire the runs into the sat input then put it to the tv . thats where i get the fuzz pic.
722k ans 222k 4tv's
- Thread starter paisley_tele
- Start date
- Latest activity Latest activity:
- Replies 2
- Views 988
What type of inputs do your TV's have?
How far is it from receiver to TV in each case?
To set up an NTSC RF feed to each TV, set the Agile Modulator on both boxes to 4 seperate channels seperated by at least 2 channels ( i.e., 21, 23, 25 and 27), join the two AM outputs with a reversed splitter then use a quad splitter to send signal to each TV.
Your 2 TVs at the receivers may not need to use the RF SD feed because of the HD direct feed from the adjacent receiver.
How far is it from receiver to TV in each case?
To set up an NTSC RF feed to each TV, set the Agile Modulator on both boxes to 4 seperate channels seperated by at least 2 channels ( i.e., 21, 23, 25 and 27), join the two AM outputs with a reversed splitter then use a quad splitter to send signal to each TV.
Your 2 TVs at the receivers may not need to use the RF SD feed because of the HD direct feed from the adjacent receiver.
