Unable to scan in on one transponder

[schlever]

I did a blind scan on my computer today of g10r and was able to find a transponder that wasn't in my list. When I added the information into my reciever (DG7000), it would not pick it up, but showed a signal with 88% quality on the transponder. Entered the pcr,vpid and apid, but still nothing. If I went back to the computer I was watching it just fine.

Any idea what I'm doing wrong?

 

[Mr Tony]

frequency info?

 

[schlever]

frequency info?

11893 V
SR = 6111
SID =1
TID = 1
APID = 3604
VPID = 3601
TPID = 0
PMT = 3600
PCR = 3601

 

[qwert1515]

Thats a feed transponder, but you say that you were able to watch it on your computer but when you went over to your DG7000 it could not lock it?

 

[schlever]

Thats a feed transponder, but you say that you were able to watch it on your computer but when you went over to your DG7000 it could not lock it?

Yes I was watching it fine on the computer, which is why I'm perplexed on why my reciever isn't locking in on it at all.

 

[Mr Tony]

try and tweak the frequency info by one or two (11894 as an example) and see what happens

 

[schlever]

try and tweak the frequency info by one or two (11894 as an example) and see what happens

As usual your advise worked Iceberg

 

[cracklincrotch]

I was about to post about this type of problem, not being able to pick up KUIL on AMC4 with my DVB card. Tweaked the frequency down 2 and bang-o.

 

[Mr Tony]

cool

i had a dg7000 clone (kusat 2600a) and had the same issues.