Welcome -
1) You have to pre-program the receiver with transponder info for active transponders on the satellite you're aiming for. One has to be selected in the tune up screen to monitor Quality
2) I think the 741 requires the skew "0" mark aligned with the very top of the dish.
3) Do not connect or disconnect any coax connections with the power on at the receiver. It may very easily burn out LNBF's or switches.
4) where on the dish did you measure "48.4 elevation"? See attached picture
5) This may be broken off into it's own thread. (hijacked)
1) You have to pre-program the receiver with transponder info for active transponders on the satellite you're aiming for. One has to be selected in the tune up screen to monitor Quality
2) I think the 741 requires the skew "0" mark aligned with the very top of the dish.
3) Do not connect or disconnect any coax connections with the power on at the receiver. It may very easily burn out LNBF's or switches.
4) where on the dish did you measure "48.4 elevation"? See attached picture
5) This may be broken off into it's own thread. (hijacked)