Anyone heard of this??-- installed a new 3-LNB dish to upgrade to HD. Sats 101 and 119 have good sigs, but 110 is in the 30's. If I rotate the dish (tilt) to the stops (140 degrees), the 110 transponders get up in the 50's-- like if I went 90 degrees, sigs would be where they should. Any chance the problem is polarization, LNB is installed 90 degrees out?
Sat 110 Reception Problem
- Thread starter sgsterling
- Start date
- Latest activity Latest activity:
- Replies 2
- Views 1K
- Status
Do you have any subscribed to services on 110?
1. Your mast must be 100% plumb and level to continue. (NO EXCEPTION)
2. Set your location specific skew & elevation mark and leave them alone.
3. Use a heading compass to eyeball your location specific azimuth.
4. If no signal is decent, bump it and give it a few seconds to register.
5. Once signal is peaked (88+) snug it.
I would use the manual selection of 3 LNB dish setup in the receiver menu.
Your receiver can give you the correct location specific co-ords, or post your zip here to make sure the ones you have are correct.
1. Your mast must be 100% plumb and level to continue. (NO EXCEPTION)
2. Set your location specific skew & elevation mark and leave them alone.
3. Use a heading compass to eyeball your location specific azimuth.
4. If no signal is decent, bump it and give it a few seconds to register.
5. Once signal is peaked (88+) snug it.
I would use the manual selection of 3 LNB dish setup in the receiver menu.
Your receiver can give you the correct location specific co-ords, or post your zip here to make sure the ones you have are correct.
Last edited:
Yes-- HBO and showtime HD are on 110 I believe, plus some others in that HD package. They are there, but full of dropouts.
- Status
Similar threads
