Right switch to connect three satellites

[marki]

I am looking for advice on which switch to use to connect satellites 61.5, 110 and 119 to the same receiver which is dual receiver DVR 721.
I do have legacy dual LNBS installed for each satellite and two feeds coming down for each of them. So, I have 6 feeds all together.
Also, can I use any kind of splitter if I decide to connect second receiver? Or it is going to be whole different setup?

Thanks a lot

 

[larrystotler]

Please move to the general forum mods.

marki: Welcome aboard. Check out this thread for more info on the switches. The first post explains each switch setup and how to get the info we need to help you:

http://www.satelliteguys.us/showthread.php?t=66374

 

[KKlare]

An SW-64 has 3 pairs of inputs, usually 119 110 61.5 for left and right-hand polarizations, in pairs. It has 4 outputs. The first must have the power inserter -- use it for a single tuner, if possible. Use 1+2 or 3+4 or some say 1+4 for a dual tuner. A tad expensive, got mine with a "must-carry" local on 148 that is not there any more.
-Ken

 

[pacman]

Yup, got mine free too when I added locals - they had to install another dish for 148 I think and the SW-64 to connect it all.