Question on motor dish

Status
Please reply by conversation.

vargf

SatelliteGuys Family
Original poster
Nov 10, 2005
47
0
Today I setup a Stab Motor (HH90) with a 40" anttena on latitude I put my latitude 34.46 Latude north now when I go to set up my Fortec Ultra Life and I put USALS for the motor I turn the 22KHz on,now the dish move but just a little and almost is in the center 180 degres Azimuth. My LNB is a Imvacom 0.3 DB Circular /Linear Quad QPH-031. I put in the center 0 tilt. My latitude North is 34.46 and my 117.19 West longitude.My dish Elevation is 39.4 but the question is corret
my set up because the 180 degre Azimuth but I don't the The True south to substrac or add , cable RG6 Can any body advice the true set up because I'm lost.
:confused:
 
The linear side of the QPH-031 is a Standard so the L.O. should be 10750 with the 22KHz off.

I would remove any switches also for now.
 
Try this

Your lat/log is like L. A. or vicinities areas, Magnetic Deviation around 15

True South - magnetic deviation

In this case: 180 - 15 = 165

Dish Elev. : 39.4

Select the nearest sat from your longitude and adjust antenna elevation and motor east/west

For you I recommed SATMEX5 116.8: Elevation 49.1, Az. 179.3

Good luck
 
Last edited:
Status
Please reply by conversation.

Cabling Questions

Now what!

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)