Programing remote
- Thread starter Mikemosun
- Start date
- Latest activity Latest activity:
- Replies 2
- Views 1K
- Status
If the receiver is in IR mode, the code to use is 00001.
But if its in RF mode, do the following:
1. dtv
2. press and hold MUTE & SELECT for two blinks
3. enter 0 0 0 0 1
4. press and hold MUTE & SELECT for two blinks
5. enter 9 6 1
6. press CH UP
7. enter the last 6 digits of the receiver ID #(RID), found on a sticker in the access card compartment
8. press SELECT
But if its in RF mode, do the following:
1. dtv
2. press and hold MUTE & SELECT for two blinks
3. enter 0 0 0 0 1
4. press and hold MUTE & SELECT for two blinks
5. enter 9 6 1
6. press CH UP
7. enter the last 6 digits of the receiver ID #(RID), found on a sticker in the access card compartment
8. press SELECT
- Status
Similar threads
- Locked
