Problem pointing 1000+ with built in switch.

[surma884]

I'm trying to point my 1000+ dish with a built in switch. The problem is that it defaults to sat 110. Meaning the stupid switch is always set to 110. I need it to be 119 so that I can point it properly. If I do check switch it only finds 110. My LNB has 110, 118 and 119. So what to do?...

BTW, my receiver is VIP211k.

 

[Dah-Henny]

You can't go to the point dish screen and select 119?

 

[surma884]

You can't go to the point dish screen and select 119?

Yes, I can do that. So even if check switch only finds 110, I can then change the sat to 119 in the point dish screen and align the dish again?

Thanks

 

[Dah-Henny]

Disconnect the coax from the receiver, run check switch to clear out the matrix, save, reconnect the coax, from the screen, select 119, then turn your dish until you get a lock on 119, run check switch, save. Hopefully that will do it for you.