I have 2 question hopefully i can get answered 1)Do I need to used a diseqc switch for this setup with a Pansat 2500a a Pansat motor and a 30" fortec dish? 2)How do I set up my dish and motor for the elevation portion do i need to align the elevation on both the dish and the motor?or do i just level out the dish elevation and worry about the motor elevation only?Any help would be appriciated thanks
Pansat Motor and Fortec Dish
- Thread starter mac21
- Start date
- Latest activity Latest activity:
- Replies 1
- Views 1K
- Status
Welcome to the forum Mac21!
1/ You should not need a switch, the cable comes from the receiver to the motor, then another cable from the motor to the LNB.
2/There are two elevation settings to be made, first the motor elevation (same as your Latitude) and then the elevation on the dish taking into account declination, I would check the motor manual for this.
1/ You should not need a switch, the cable comes from the receiver to the motor, then another cable from the motor to the LNB.
2/There are two elevation settings to be made, first the motor elevation (same as your Latitude) and then the elevation on the dish taking into account declination, I would check the motor manual for this.
- Status
Similar threads
