New member here with odd problem.
Just upgraded to the large dish and a brand new HR20-100S about 3 weeks ago. Installation went well and system mostly worked. Installer had to return and do something so that we got all the HD channels. (I wasn't home and wife reported that he did "something"!).
Fairly simple setup....
HDMI to Sharp Aquos 37 inch and digital optical audio to receiver.
All was well until last weekend at which point two things happened:
First, the sound stopped working (replaced the digital optical cable...still doesn't work....so went back to cables and it worked again).
Second.....the TV began to report that it was "receiving invalid control signal" and turned off (I think this is only with 480i, but am not sure) Replaced HDMI cable....no change....when went to component cables it all works again.
I felt it was likely that the DVR had failed and Direct TV agreed and shipped me a refurbished HR20-700. I've protested and after 2.5 hours on the phone with them, they offer NO solutions. We have no way to get you another HR20-100...period so shut up and take the HR20-700.
Three questions for you then, if I may....
1) Does it seem likely this is a problem with the HR20-100 (the loss of sound and failure of the HDMI to work correctly?
2) Is there any way to actually GET an HR20-100S as a replacement from Direct TV?
3) Should I just say the devil with it and run the component cables and the audio cables?
Just upgraded to the large dish and a brand new HR20-100S about 3 weeks ago. Installation went well and system mostly worked. Installer had to return and do something so that we got all the HD channels. (I wasn't home and wife reported that he did "something"!).
Fairly simple setup....
HDMI to Sharp Aquos 37 inch and digital optical audio to receiver.
All was well until last weekend at which point two things happened:
First, the sound stopped working (replaced the digital optical cable...still doesn't work....so went back to cables and it worked again).
Second.....the TV began to report that it was "receiving invalid control signal" and turned off (I think this is only with 480i, but am not sure) Replaced HDMI cable....no change....when went to component cables it all works again.
I felt it was likely that the DVR had failed and Direct TV agreed and shipped me a refurbished HR20-700. I've protested and after 2.5 hours on the phone with them, they offer NO solutions. We have no way to get you another HR20-100...period so shut up and take the HR20-700.
Three questions for you then, if I may....
1) Does it seem likely this is a problem with the HR20-100 (the loss of sound and failure of the HDMI to work correctly?
2) Is there any way to actually GET an HR20-100S as a replacement from Direct TV?
3) Should I just say the devil with it and run the component cables and the audio cables?