L401 has still killed my OTA locals, yes I have done check switch and power cord reboot, both several times. This sucks!
I have that problem too. Happened last night and again today. Last night I did a power button reset which cured it and today I tried a check switch and that also cured it. This must definately be a new bug.
Since I recieved L401, my OTA locals have become unwatchable. Don't have this problem on my 942. Anybody else having this problem? When I call dish they always say to push the power button. The problem ppersists.
Would a refurbished replacement 622 authorized today get 401?
I agree . That is what I did to clean up the sd uplicates . I lock all channels out I don't like or need. As I reported earlier in this thread , the problem with this software is that when you lock out the hd channels in the 9000 range or the hd locals in the 6000 range , you will not get any search results for those channels in either the 9000 range or the mirrored lower channel numbers. I use the search features to look for movies in the system daily to see what I want to record. This is a bug . It will eliminate the ability to replace all the sd channels with their hd counterparts if the search features don't work with them.
I too have lost all of my OTA locals since the L4.01 update. ...All locals were working flawlessly before i did the re-scan...
I guess I'm not a very good beta tester. I deferred that test for fear I would lose my OTA which are currently working fine. I did that based on reports here.
Of course if I were a real beta tester, I assume I'd have a dedicated box on which I'd not mind something going wrong.
I noticed a problem with the new software on 622. There seems to be a glitch that is only affecting my HD locals. The DVR now will not playback anything that was recorded on the Charlotte locals off 118, however anything recorded on the off-air antenna or any other hd channel still works properly. I already have contacted dish about this problem and after convincing the tech that it's not a timer related issue he aggreed that it's most likely a problem with the L401 software that had not been reported yet. The problem even occurs when you manually try to record. you go back to your DVR menu and select it and all you get is black. Well anyways the tech said to wait 2 days and if the problem still exists to call back. Anyone else noticed this problem?
I have noticed very slow channel changes with 4.01, whether from the guide, channel up/down, or by entering the channel number.
...There surely should be a orientation setting to tweak the output and since you stage the other model has one.....why not this one ?
seems an obvious feature to center your output since there are only hundreds of TVs...