I'm not buying it. One of the inputs will not be active at the Duo Hub, so no way you can run 2 receivers of 1 input, and if nothing else, no way you can run them as they're intended to work, all tuners, all sats, etc
Need Wiring diagram for 1 Hopper 3 and 1 Wally thanks
- Thread starter Conway
- Start date
- Latest activity Latest activity:
- Replies 32
- Views 8K
No you can't!! If you could do that then why did Dish have to come out with the DPH42 to support 2 Hopper 3's?
Sorry, but you are flat wrong on this one.
I don't recall doing this lately.... but how come that you can re-point the dish with hybrid lnb and hopper 3 powered on, if port 2 is disabled?
I would suggest that people who do this for a living should become better acquainted with how these things work.
That what i know is that always when i connect the meter to port 2 on hybrid LNB it worked just fine 
Yes, if the Hopper 3 is turned off then port #2 will show a signal on a meter sometimes. Sometimes it will even show a signal with the Hopper 3 turned on except the signal is immediately lost on the Hopper 3 when the meter locks on.
But the point is that you can't have another receiver that works attached to port #2 if a Hopper 3 is working on port #1. Can we agree on that?
I think I just read 28 confusing posts about port 1 ,2 and even 3 . I need a beer.
Sent from my iPhone using the SatelliteGuys app!
Sent from my iPhone using the SatelliteGuys app!
You can't. You have to remove the cable from the back of the Hopper 3. Hopper Duo's are the same way
Sometimes it will even show a signal with the Hopper 3 turned on except the signal is immediately lost on the Hopper 3 when the meter locks on.
........ Can we agree on that?
We may agree on this.Never tried second receiver on port 2 with Hopper 3, and never observed if the hopper 3 have signal at the time I adjusting the dish.
But I always attach my meter on port 2 on hybrid LNB and always works
We did agreed that the official way is DPP LNB and 42 switch or second dish.
With 1k2 DPP LNB you can attached the Wally straight to port #1 or #3 on the LNB or to the 42 switch port - 2.
....from there you can experiment as much as you want.
My installer tried to run 2 lines from a hybrid lnb into Duo hub when I first had my two Hopper3 receivers installed. Of course it would not work. I finally showed him how he needed DPP lnb and a DPH42 switch. I showed him the diagram and pictures from the SatelliteGuys website. You need to listen to JSheridan and Hipkat. They know what they are doing.
Sent from my iPhone using SatelliteGuys
yes my installer tried the same thing with 2 hopper 3's running both on a Hybrid and Duo Hub.. it did not work. So he had to put on a DPP LNB and a DPH42 with power inserter. works just fine now.
Similar threads
