MicroHD and DiSEqC 1.2

[jibaro29]

I am not sure how it happened but it did. My sat system consist of two dishes. One for Ku and the other for C band. I have been working with this setup for a while now. A few weeks ago the Micro started to not recognized the DiSEqC. I tried switching ports and nothing. I get no signal from lnbfs. I thought that the switch was bad. So instead of replacing the switch I replaced the receiver. The Manhattan had no issues with the DiSEqC. Has anyone encounter the same situation?

 

[primestar31]

Did you power cycle the MicroHD?

Perhaps the userdb.udf file got "funny" (corrupted is some odd way, but not enough to boot-loop). Try reflashing the firmware back to the latest load. If you don't have a backup of the userdb to reload from before it went "funny", you'll have to re-do the settings and such up from scratch.

 

[chaskuchar]

I had a problem last fall when I got my new microhd. I could load and old userdb file and it would move the dish but when I did a factory reset it would not move the dish until I loaded the old userdb file and even then when I added a new satellite it would not move the dish in setup. Eugene from satav had me reload the firmware from the satellite. I think that fixed it. charlie