Since the 3/7 CE software download, I've been having audio problems with my HR21. This is version 0x206.
It manifests as an audio loss, for less than a second (probably less than 1/2 sec). Sometimes this occurs a single time; sometimes it occurs numerous times for a few seconds. The video is usually nominal when this occurs, but I think I've seen some occasions where a frame or so is dropped. This is not the same as the pixilation artifacts I've seen, for instance when the signal is on the ragged edge, nor is it the fault I attribute to a codec execution problem where a mpeg frame division fails, but the rest of the frame is OK.
I didn't notice this before the 0x206 download. Ironically, I downloaded this version because of failed recordings using the previous version. So, I'm not convinced this is a software problem. Other perhaps relevant observations. Seems to do this whether or not recording is going on. Does this on any channel. Signal strength is still up where it was when the KA dish was installed. Self test passes. Internal temp not high (116 degrees) Perhaps worse while recording, perhaps worse while recording HD, but not always. As I'm typing this, I'm recording John Adams in HD, and watching it real time, and there have been no audio faults for the past 30 minutes. There were numerous faults before the last 1/2 hour.
Any one else seen (heard) this? Any ideas are welcome, especially any method to test further.
Rich Miller
It manifests as an audio loss, for less than a second (probably less than 1/2 sec). Sometimes this occurs a single time; sometimes it occurs numerous times for a few seconds. The video is usually nominal when this occurs, but I think I've seen some occasions where a frame or so is dropped. This is not the same as the pixilation artifacts I've seen, for instance when the signal is on the ragged edge, nor is it the fault I attribute to a codec execution problem where a mpeg frame division fails, but the rest of the frame is OK.
I didn't notice this before the 0x206 download. Ironically, I downloaded this version because of failed recordings using the previous version. So, I'm not convinced this is a software problem. Other perhaps relevant observations. Seems to do this whether or not recording is going on. Does this on any channel. Signal strength is still up where it was when the KA dish was installed. Self test passes. Internal temp not high (116 degrees) Perhaps worse while recording, perhaps worse while recording HD, but not always. As I'm typing this, I'm recording John Adams in HD, and watching it real time, and there have been no audio faults for the past 30 minutes. There were numerous faults before the last 1/2 hour.
Any one else seen (heard) this? Any ideas are welcome, especially any method to test further.
Rich Miller