Hr20 700 Dvr At9 Dish Setup I Haven't Seen

[cw18306]

HR20 700 DVR AT9 Dish Setup I Haven't Seen...HELP!

Hi, I have the HR20 700 DVR currently hooked up to a 3LNB dish. D* is coming to install the AT9 tomorrow. I do not have any other receivers to hook up.

This is my cable situation. My house is wired for cable, but I ONLY have a SINGLE cable input coming out of my wall face plates. I have a DI-PLEXER attached to it and run 1 cable to the TV antenna, and 1 cable to the DVR's SAT1 input. I know I will need to run a 2nd cable to the SAT2 input on the DVR.

How can I run 3 coax cable's to the DVR with only 1 cable input on the wall face plate? I do not want to drill holes in the floor or walls. Is there a way around this? Thanks!

 

[Steelr7]

You need to pull another cable in the wall, along with the existing cable. Then you use a 2-outlet wall plate.

 

[damaged]

Not to mention, it is likely your diplex will not longer work once the AT9 is installed, if not now, later when it goes full capacity, so you will need 2 feeds from the dish to your DVR and another for OTA (not diplexed).

 

[cw18306]

Thanks guys. I was worried about that. I have a video/network hub, that is a juction box, my phone and cable lines feed through. I have 4 different rooms all wired in 1 box. Each is fed through a 2" pvc tube. Unfortuately, both the telco and coax that run to all face plates are braded together...Grrrrrrrr!!!!! Any advice?

 

[cw18306]

I got it. I had to go under the house. My cable, phone, and data lines feed through a pvc tude directly under each face plate in each room! All I need to do is run the lines under the house and add both SAT line up and attach them! Silly me...:lol !