O.K. going two dedicated motorized dishes one for C-Band one for KU, 4x2 DISEqC or 22khz. switch. I'm tired of seachhing and I have a PS dish here ready only need the motor and mount it.
Found my old Equipment. Need opinions?
- Thread starter GetBit03
- Start date
- Latest activity Latest activity:
- Replies 29
- Views 5K
- Status
Shopping List:
Micro HD Receiver
C-Band only LNBF
18" Actuator
VBox 7 positioner
HH motor for ku dish
4x1 DISEqC switch
Anything else??? I would like to be prepared and ready to install.
Micro HD Receiver
C-Band only LNBF
18" Actuator
VBox 7 positioner
HH motor for ku dish
4x1 DISEqC switch
Anything else??? I would like to be prepared and ready to install.
Looks similar to one my lists of a few(??) yrs ago.
Just don't rush to get it all up and running at once. Get the BUD operational then you'll have something to watch as the cement cures around the Ku dish pole. Then add the switch and Ku and get it going.
Just don't rush to get it all up and running at once. Get the BUD operational then you'll have something to watch as the cement cures around the Ku dish pole. Then add the switch and Ku and get it going.
Yep yep that's all covered. I buy in bulk! Have 500 feet of c band dual feed with motor and servo wires brand New in the box!
From what I've read all I need for the 6' fully aluminum mesh bud is a 18" actuator correct?
Everything is on it's way! Should be watching TV Next week! Crossing fingers!
Pole mounted
PS face lift
PS on pole
Bud Facelift (just need to mount LNBF, actuator, wire and install LNB cover
Pole mounted
PS face lift
PS on pole
Bud Facelift (just need to mount LNBF, actuator, wire and install LNB cover
Last edited:
Not 100% comfortable with your Ku dish.
- height of LNBF looks questionable
- pole diameter looks too small
- the round feedhorn isn't optimal on an elliptical dish
Let us know how well it works out.
- height of LNBF looks questionable
- pole diameter looks too small
- the round feedhorn isn't optimal on an elliptical dish
Let us know how well it works out.
The pole is too small for the dish but I just set the dish on it for a pic. The pole is to mount the motor the dish will be on the motor but I don't have the motor yet, it is on its way. I have used a LNB just like this on a 84e PS dish back about 7 years ago and it worked excellent?? It is fully adjustable but I have not adjusted it yet, no receiver to test. If I remember I didn't need to adjust anything but the skew up and down was spot on. Guess I will see??
- Status
