DiSeqc or Multiswitch?

[Larobpra]

I have a dual output (H+V) P* LNB that I want to try on the 90cm CM just to see if it would give me enough quality to make RTV watchable. Do I need a multiswitch - which I don't have - or can I combine the 2 with a DiSeqc switch?

 

[brentb636]

I think a Diseqc would work, but you'd have to simulate 2 satellites, one for the Vertical polarity and one for the Horizontal polarity. A little kludgy maybe . RTV is Horizontal polarity, so you actually don't need the Vertical polarity at all. For your purpose , just hook up the cable directly to the H port on the lnbf.

 

[Mr Tony]

agreed with brent. Just use the H side

but later on a multiswitch would be easier if you motorize the dish

 

[Larobpra]

Dish is already motorized. If it was fixed I'd just use the H port as suggested. The multiswitch would go between the LNB and the motor, correct?

 

[Mr Tony]

yes

receiver----motor-----multiswitch----LNB

 

[Larobpra]

Thanks! I'll post results when I get one and get it hooked up.

 

[Mr Tony]

EBay has them pretty cheap. Heck get a 4x4 then you could add a DBS LNB to it too
(and it seems the 4x4's go cheaper than the 3x4's)

 

[brentb636]

I just ordered 2- 3x4 Zinwell multiswitches ( free shipping ) for $15 total. A make an offer listing. Accepted and shipping.