DiSEqC a no go problems

[jibaro29]

Hi guys,

I finally did it. I took off the east limits on my SG2100and ever since then I have nothing but problems with the DiSEqC. The USALS works great with most of the Sats. However, there are a few that I have to tweak and that is when the diSEqC goes ape Sh...t. It doesn't matter how many times I set up a Sat with the DiSEqC it won't remember to go back to that position. What it does is it goes back to O or some were near it.

I have done a master reset, I have changed the cables, I even switched motors and the problem still there. Ok you may think is probably my receiver, Right? Here is the strange thing I also have two units and is doing the same thing on both of them. If it is a software problem I would be totally .

Why did I removed the East Limits? I wanted to get Telstar 12 @ 15W and Atlantic Bird 1 @ 12.5W.

I would appreciate any inputs from you guys.

Thanks!
__________________
Fortec Star Mercury ll
Fortec Star CLASSIC NA FTA
Digipower SG-2100 DiSEqC Motor
1.0 Ku Dish
QPHO31 Invacom 0.3 Ku LNBF

 

[Mr Tony]

are you in an area that can see those satellites?

If the dish hits anything the motor will reset back to zero. My motor does that if I try to go to Hispasat...the dish touches something and the motor goes back to my true south

 

[jibaro29]

Ice,
As far as I can tell there are no obstructions. When I removed the east limit I was able to lock in these two sats without adding a second lnb to the dish. In retrospect I wish I hadn't done it. Now my problem is that the DiSEqC will not work as good as it should.