Connect two 9241's with an sw44 switch

[bcondemi]

Sorry but been looking for an answer for days now....I hope I'm in the right place....

I have now a 2 dual lnb's and an sw44 switch (all 4 cables are connected). 1 and 2 are connected to my first 9241. I just got another 9241 and connected 3 and 4. however, I can't get the reciever to get both satellites? What is the correct cable connections and will the sw44 work for this setup?

BC

 

[Slartibartfarst]

Nothing wrong with the way it is wired but I would check the connectors and the cable to the 2nd 9241. Don't forget to run a check switch. Look for old cable splitters on the cables too.

 

[Mikey11]

that should work, do you have the power inserter connected to port one?

sounds like a bad cable or connector/cable end

 

[QCK]

Do you have both cables from either 82W or 91W going to 1a & 1b and the other satellite position on 2a & 2b? You cannot cross over the satellite positions between 1 & 2 on the input side.