I was wondering now that I got a motorized system working great.
Can't say how much thanks for all your guys help.
I still had a few more questions.
First of all. I have been looking around for Channel 1. Not the foreign channel 1. But channel one for school. All I found was complaints about it. Not what Bird it is on, encrypted or on KU band.
Any ideas?
As a side note since this is education and they do show comericals. One would think this would be free. But I doubt it. Since it is all marketing and contracts.
I got a motorized system and a stationary dish. I connected the 2 via discq switch. After the motor ofcourse. When I change between channels the dish still moves. Read about a simple A/B manual switch and a 22khz switch does not work before the motor. Any other options?
* On a side note. I'm looking at another receiver for FTA only. Is this is the case. What is needed to hook up and split the signals from the satellites. I do realize if the motorized dish is on a sat. Then only both recievers have to use that satellite. Read there was some kind of splitter switch. Either that or I can use the loop out connector.
When I got my quantum msr-500 receiver. It came with a etNetworks smart card in the system. I reset the system and cleared it off. So I don't have any transponders entered or anything. But is this card good for anything? Anybody have any ideas on what satellite the channels are on?
Thanks,
Josh
Can't say how much thanks for all your guys help.
I still had a few more questions.
First of all. I have been looking around for Channel 1. Not the foreign channel 1. But channel one for school. All I found was complaints about it. Not what Bird it is on, encrypted or on KU band.
Any ideas?
As a side note since this is education and they do show comericals. One would think this would be free. But I doubt it. Since it is all marketing and contracts.
I got a motorized system and a stationary dish. I connected the 2 via discq switch. After the motor ofcourse. When I change between channels the dish still moves. Read about a simple A/B manual switch and a 22khz switch does not work before the motor. Any other options?
* On a side note. I'm looking at another receiver for FTA only. Is this is the case. What is needed to hook up and split the signals from the satellites. I do realize if the motorized dish is on a sat. Then only both recievers have to use that satellite. Read there was some kind of splitter switch. Either that or I can use the loop out connector.
When I got my quantum msr-500 receiver. It came with a etNetworks smart card in the system. I reset the system and cleared it off. So I don't have any transponders entered or anything. But is this card good for anything? Anybody have any ideas on what satellite the channels are on?
Thanks,
Josh