I am scratching my head over this one. I bought the Avenger pll lnbf 321s-2 for upgrade to my Openbox s10. I installed this puppy and am receiving 0 signal. Am i missing something here? I just figured i received a defective since by hooking my old lnbf back in place restored signals. I received the replacement Avenger and installed it to find the same results, no signal. I took my satellite meter to the dish to check the Avenger and have no signal with it also. Do you have any ideas guys?
Avenger pll lnbf
- Thread starter dobiegillis
- Start date
- Latest activity Latest activity:
- Replies 9
- Views 2K
There doesn't appear to be a choice of lnlb settings in this s10. It is either on or off. Old lnlb is a standard. Receiver set for 10750. Avenger lnlb is universal.
I just bought one too (Avenger PLL321S-2) and I also have Zero signal.
For $10 it was worth a try.
I've got the GloryStar setup (Geosat Pro 1200) with the GeoSat PLL. I put the GeoSat PLL unit back in, and everything is fine again.
I lined up the arrows on the Avenger just like the GeoSat
The present setting is 10750 and the 22 tone is on.
A previous post indicated that the LNB setting may have to be changed for the Avenger.
I'll try again
For $10 it was worth a try.
I've got the GloryStar setup (Geosat Pro 1200) with the GeoSat PLL. I put the GeoSat PLL unit back in, and everything is fine again.
I lined up the arrows on the Avenger just like the GeoSat
The present setting is 10750 and the 22 tone is on.
A previous post indicated that the LNB setting may have to be changed for the Avenger.
I'll try again
That worked. However I didn't find any difference in signal strength or stability over the GeoSat PLL LNBYep change your LO to 10600 and it will most likely work then.
And you won't. I have 3 Avenger PLL LNBs and 1 GeoSatPro PLL. I don't see any difference other than I have a 33" dish which got dented. Aimed at 125W the Avenger manages to receive PBS and Montana. I can't get the GeoSat to do the same.
