The 24 Volt Von Weise Actuator on my 12 Foot Mesh Dish is frozen or not moving I get the E2 Error Message but I can move it slightly 1 or 2 steps till E2 comes up. It is 8 years old and very rusty. I want to replace it with with a 36 Volt Von Weise Actuator that runs well but has a circuit board on it and did not work years ago with my V Box III. Somebody told me at the time that it didn't work cause it has a Optical Sensor. Is there any way I can get it to work with my V Box III as it has a Circuit Board attached / wired to it on 3 Terminals that can be removed. Can the circuit board just be removed from the 3 wires it's on? But not sure if this Actuator has a Reed Sensor as it's not plastic but looks black with notches. I have detailed pictures - will try to post them. Any replies would be very much appreciated.