Search results for query: *

  1. rsellers1971

    Gtmedia V8 Finder 2

    Ok thanks
  2. rsellers1971

    Gtmedia V8 Finder 2

    I bought it for the actual vendor, i am surprised the can sell them this way. I was gonna buy an actual receiver for another dish i am setting up i currently use Octagon but don't want to spend that much this time, do you think i should avoid them?
  3. rsellers1971

    Gtmedia V8 Finder 2

    I bought one from ebay, and tested it with my dish on 101w however it scans in encrypted channels like comedy central and nickalodian and they play. Is is normal?
  4. rsellers1971

    Chaparral Sierra 3 question

    I thought that might have been part of it, i bought this thing used just to drive the actuator and the polarotor. Does anyone know the wireing schematic for the actuator? It appears to have two main wires and three smaller. Thanks
  5. rsellers1971

    Chaparral Sierra 3 question

    Do these drive the actuator? They have a selection fir satellite up and down but i can't figure out where they would tie the wires in on the back. Thanks
  6. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    Thank you, questions, I am sure I will have many! Have a great weekend.
  7. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    I seen than just now, I did my initial search on eBay. Ok Thanks, I will likely get the dish this weekend and report back !!
  8. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    Awesome, so with the Titanium ASC1 I am basically stuck on one sat?
  9. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    So the Titanium ASC1 is programmed with the satellite positions and drives the powered arm on the dish. It looks to be about $175. The receiver is about $100 bucks. Then whatever dish hardware that has to be upgraded.
  10. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    Thanks for the info, I will be upgrading the receiver but was hoping to 'get in the door' so to speak without spending too much to start.
  11. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    I think this dish is complete so it should have the motorized actuator still attached. The dish itself will require power? This is the only thing i cannot get with the dish is plumbing as its buried! I will most like have to cut is at the ground level. Does the receiver supply power to the...
  12. rsellers1971

    NEW TO FTA - NEW INFO! LOL

    I know basics about FTA and have general knowledge but I am curious about setting up a dish. I picked up a Pansat 3500SD receiver pretty cheap and an older gentleman about 4 houses down from me has a 10' mesh dish will all its nose hardware will in tack, still in the ground. 1: Will the...
Top