stab 120hh returns to zero

[danielsender]

Hi,

Sorry if this question was already answered but I'm new to this forum.

Here in N. California I installed a 120cm dish, with a quad invacom LNB, a 120hh stab rotor and a Pansat 3500s. Everything works quite well. As I search for the T5 or G10 birds the signal are good. But the problem is when I go to a "far away" satellite such as Nahuel 1, that for me is at 55 deg east. For a few seconds the picture is good but after it goes back to the reference point without any intervention. I thought that could be related to a East-West limits settings, but within USALS and the Pansat 3500S I don't see anything related to limits. Is this some kind of malfunction or some wrong setting? Many thanks in advance.

Daniel

 

[danielsender]

Reading the manual of the stab 120hh I found part of the answer to my question. It says that it has internally memorized software limits at +- 50 deg. So in my Pansat 3500S I don't see anything about limits in the USALS mode. However in diseq1.2 it says disable limits but it doesn't do anything. How do I positively remove the soft limits? Thanks.

daniel