I have recently purchased and received most of the parts and ready to setup, but having difficulties. Hoping someone can help me with this. My zip code is 77077.
Correct me if I’m wrong.
1) I see 4 ports from LNBF. Alternating L and C. I’ve used first set of L and C to SAT1 and SAT2 on DiSEqC switch.
2) I hooked up OUT from the switch to the IF IN on the receiver. Once I get the rotor, do I hook up OUT from the switch to rotor’s LNB and rotor’s Receiver to the IF IN on the receiver?
3) Installation menu on my receiver has the list of the satellites on left pane and on the right has lnb type, lnb local frequency, 22kHz, DiSEqC, Skew, TP, Positioner Setting, and Satellite Scan. Let’s say I want to connect to T-5/KU satellite, what are the settings and where do I point my dish?
This is what I’ve purchased.
Pansat 3500sd,
Fortec 35' dish,
STAB HH-90 rotor (haven't received yet),
Invacom QPH-031 Quad LNBF, and
4x1 DiSEqC switch.
Thank you in advance.
Correct me if I’m wrong.
1) I see 4 ports from LNBF. Alternating L and C. I’ve used first set of L and C to SAT1 and SAT2 on DiSEqC switch.
2) I hooked up OUT from the switch to the IF IN on the receiver. Once I get the rotor, do I hook up OUT from the switch to rotor’s LNB and rotor’s Receiver to the IF IN on the receiver?
3) Installation menu on my receiver has the list of the satellites on left pane and on the right has lnb type, lnb local frequency, 22kHz, DiSEqC, Skew, TP, Positioner Setting, and Satellite Scan. Let’s say I want to connect to T-5/KU satellite, what are the settings and where do I point my dish?
This is what I’ve purchased.
Pansat 3500sd,
Fortec 35' dish,
STAB HH-90 rotor (haven't received yet),
Invacom QPH-031 Quad LNBF, and
4x1 DiSEqC switch.
Thank you in advance.