New to Directv after having Dish for 10yrs. Had install last Tuesday and every once in awhile when I change channels the screen will go black and TV says no input. Genie is on but seems like it is locked up. If I turn Genie off then back on picture comes back. It doesn't happen a lot, but just a little annoying. Any ideas?
Losing picture
- Thread starter repcmm
- Start date
- Latest activity Latest activity:
- Replies 8
- Views 1K
- Status
I have this happen when I turn the system On, for a split second but only when its first turned on.
I know the reason though, its due to the amount of time I have my remote set to turn things on.
Changed resolution to 1080i/1080p only and turned native off. So far no problems, but haven't watched much TV since change. I did notice it happened a couple of time when I switched to encore or non HD channel. Hopefully these changes will work.
You can also try to change out HDMI cables. I had this happen to me on an HDMI cable that was starting to go bad. Reseating the cable also helps.
Did it do that with encore or non HD channel after you made the changes to the settings?
Played around with switching from HD to encore and non HD and so far no problems. Hopefully that fixed it
Thank y'all for the help. New to Direct and learning all the new stuff, I just could not pass on the unlimited data offer from AT&T.
I do miss Dish but I will survive, I don't watch a ton of TV
Thank y'all for the help. New to Direct and learning all the new stuff, I just could not pass on the unlimited data offer from AT&T.
I do miss Dish but I will survive, I don't watch a ton of TV
- Status
