Invacom QPH031 setup

[panollaureiro]

Kurtsat:

I also received Invacom QPH-031. I would like some advise when connecting the lnb to a 4 in 1 DiSeqC Switch.

Is there any available diagram I should use? Could anyone send me a sketch?



I am also planning to hook-up like this:

QPH-031:
L -> Disecq on Port 1
C -> Disecq on Port 2

Disecq -> Motor -> Receiver..

Waiting for any answers...

 

[iafirebuff]

I am thinking of getting this LNB also. Would be handy.

 

[Mr Tony]

I am also planning to hook-up like this:

QPH-031:
L -> Disecq on Port 1
C -> Disecq on Port 2

Disecq -> Motor -> Receiver..

Bingo..thats all you need to do
You only need two lines to the switch

 

[Mr Tony]

I am thinking of getting this LNB also. Would be handy.

I had one but sold it...due my far northern location and the way my setup is, the LNB was too heavy and actually made the signal worse

I use a Sadoun dual and a DBS hose clamped together...much lighter and gets the job done

 

[updatelee]

its a heavy lnb thats for sure. sure got a nice low noise floor.

 

[iafirebuff]

I had one but sold it...due my far northern location and the way my setup is, the LNB was too heavy and actually made the signal worse

I use a Sadoun dual and a DBS hose clamped together...much lighter and gets the job done

That's good to know. I have been happy with sadoun and fortec LNBS. I put a bid in on one on ebay, so will see