if i want to run both an analog and dvb reciever how do i set up polarity control?

[drhydro]

Howdy folks,
I have a quick question. If i want to use both an analog reciever and a dvb receiver, how do i wire the polarity control so that both recievers can run it?
thanks in advance
thomas

 

[BFG]

you would use two high freq spliters and a diseq 2X1 switchh as displayed here:
http://www.dmsiusa.com/add_a_receiver.htm

oops, I relized I probably didn't answer your question. but to move the dish you'd still use your analog receiver.

 

[drhydro]

Thanks for the info, mucho appreciated

 

[drhydro]

still kinda confused tho, which reciever is controlling the polarity?

 

[drhydro]

ahhhhhhh found a diagram that i think explains it all here
http://www.dmsiusa.com/splitter,0_12v_switch.htm

 

[Diamond Jim]

I have a Motorola 922 and a Satworks 3618. I have the C and Ku lines from the dish split and one side goes direct to the 922 the other sides run into the DiSEqC, then into the LNB port on the 3618. This is called a "slave." All of the functions, polarity, dish motor etc are run by the 922. See PSB for a hook up kit.