I am trying to set up a Hopper receiver myself. Have not connected Joeys yet but proceeded to boot up the Hopper and verify signal. It goes through the Dish logo screen a few times and the Attention 833 Message screen re switches and eventually moves to another Attention 833 screen that reads "Please wait while your network table is updated." And there it stays stuck. Will not go farther than that. I've searched the forum and the web but cannot find any info re this. Any help/suggestions would be appreciated.
Hopper Setup Issues
- Thread starter pure life
- Start date
- Latest activity Latest activity:
- Replies 8
- Views 11K
Same dish I used for my 922 receiver. I'm getting good signal and it is pointed correctly. I'm using a solo node. The setup guide warns to not connect any Joeys with coax until Hopper displays live TV, so no Joeys connected yet.
I just installed a bought Hopper and never saw that error message. Mine did do a check switch, twice. It also checked satellite signal, twice. But I never saw the error or info you asked about.
Actually after FOUR hours stuck on the screen with that message it finally moved on in the set up wizard process, TV resolution, etc., and I am at the last step--calling Dish for activation. It said it updated the receiver with the latest software so perhaps that's what it was doing. But 4 hours seems like an inordinate amount of time. Thanks all for the suggestions.
