Found 10 ft. dish and will need help...

[xxtornxx]

Anole may be you can take a wide out pict. of your motor set up and it will show wireing and your plastic cover and sensor. That if looks like the motor I am useing or know of some one to post pic.

 

[xxtornxx]

making proto type for cover

 

[Anole]

Yea, three screws and three washers, and your disc should be fine.

If you read the thread by Linuxman on the AJAK, then you've seen about everything you need.
If there's more, I'll shoot the appropriate pictures.

Send me your mailing address by PM (private message, here on the forum) and I'll try to slip a reed switch in an envelope and get it out to you.
No charge - just good will to a fellow forum member.

 

[xxtornxx]

thank you...Anole

 

[Anole]

good news; bad news:

PM received ; reed switch sent.

BUT . . .

While checking the (brand new) reed with a magnet, I discovered something.
I'll discuss it in the thread Linuxman started last month on the AJAK motor/magnet/reeds when I know more.
May take a few days to figure out what's going on.