Here's my setup at home:
Dish 1000.2 dish, output one goes to a seperator to a Dish 722. Output 2 goes to a seperator to a Dish 625.
We just setup a campsite where I installed a used Dish 500 with Plus/Pro Twin LNB. (Same exact setup I had before going with the HD package. I brought the 625 receiver over and hooked it up with the separator. When I do a check switch I get 110 OK, but where 119 normally would be it just says Conn.
If I go to the point dish screen I'm getting pretty good signal on both 110 and 119 (looking at transponder 11&12 as my searches suggested).
Obviously I'm missing a lot of channels with this setup, but what's confusing me is that I can see signal from 119 on the point dish screen.
What am I missing here? So far I've tried using both inputs/outputs on the receiver/lnb without the separator, and flopping the outputs as well.
Pic on my check switch below (hopefully picassa doesn't remove it)
Dish 1000.2 dish, output one goes to a seperator to a Dish 722. Output 2 goes to a seperator to a Dish 625.
We just setup a campsite where I installed a used Dish 500 with Plus/Pro Twin LNB. (Same exact setup I had before going with the HD package. I brought the 625 receiver over and hooked it up with the separator. When I do a check switch I get 110 OK, but where 119 normally would be it just says Conn.
If I go to the point dish screen I'm getting pretty good signal on both 110 and 119 (looking at transponder 11&12 as my searches suggested).
Obviously I'm missing a lot of channels with this setup, but what's confusing me is that I can see signal from 119 on the point dish screen.
What am I missing here? So far I've tried using both inputs/outputs on the receiver/lnb without the separator, and flopping the outputs as well.
Pic on my check switch below (hopefully picassa doesn't remove it)