Search results for query: *

Well, I got a replacement LNB, hooked it up, came inside and voila, got even and odd, good signal strength on all. Downloading the software upgrade now. Thanks to everyone that lended their advice :)

Thanks. I just went and replaced all of the wiring with factory terminated RG6 rated for 2300Mhz, advertised as "for digital satellite installations", and put barrel connectors in place of the wall plate and ground block. Tweaked the dish a little, and have signal strength 100 for 110, and 80...

Aye, the download sits at Acquiring Satellite. I saw in the manual reference to trouble if you 'only get odd transponders', but I'm actually only getting even transponders signal strength for all odd transponders is dead at zero. I have the RG6 going from the receiver to a wall plate, then to...

Thanks folks. Finally got a signal - I didn't realize just how touchy it was. I've been fiddling with it all night and have a decent (above 80) signal on both 110 and 119. The only 'odd' thing now is that there is only a signal on the even transponders, zero signal on the odd ones. I'm done for...

Thanks for the reply and assistance... I've tried using the signal meter to tune it in, but it has never gone above zero - I guess the only other thing to try is adjusting the elevation or skew slightly and try, try again, but there hasn't even been any hint that it might be 'close'. One...

Right, I'm just trying to make sure that this message is OK to see: "Warning 530: One of the satellite inputs or switches is not connected properly. Normal operation will be adversely affected" The problem is that signal strength is zero. I have the elevation and skew perfect according to...

Thank you... One other thing, though - assuming that I'm actually not receiving a signal from the satellite, is it still normal to see that "Warning 530" message, or is there something else wrong here? The way the 530 message is worded sounds like there is a physical connection problem, not a...

Hi guys, I have a new DVR-625 that I'm trying to set up with a DishPro Twin LNBF... In trying to isolate my problem, I'm trying to figure out the meaning of two things: 1) When the Check Switch test finishes, it displayes the message "Warning 530: One of the satellite inputs or switches...